Cecelia
- Total activity 50
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 26
Articles
Recent activity by Cecelia-
Steps on how to replace z assembly for UP mini2/ ES
Power off the printer, take off the proofboard first. 2. Take off the Electronic heater platform assembly: unclip side tabs. Caution don’t lose springs underneath. You will have to raise the pla...
-
Method of replacing FFC-Y axis cable and Y-axis limit on UP300
Tools Cross screwdriver, 2.5mm hex wrench First remove the aluminum column, the rear plate and the right side plate with a hex wrench; Use a cross screwdriver to remove the two screws fastening th...
-
Motion System Error X-Y-Z-
Motion system error primarily due to the issues related to limit switch. The software usually gives motion system error (x/y/z) to hint which axis is being affected. Possible casues : Broken lim...
-
How to Replace Plastic Pulley with Wheel Assembly of UP300
After long-term using, some plastic spare parts may be broken, this article will guide you how to replace Plastic Pulley with Wheel Assembly for UP300. Tools: forward and reverse ratchet screwdrive...
-
How to replace FFC platform on UP mini2/UP mini ES
Power off the printer, pull out the cellboard. Take off heating plate assembly from the four snaps shown. Pull out FFC cable plug from the heating plate. Remove the platform FFC cable from the ill...
-
Platform too hot error
Following possibilities could make Platform too hot error : 1.Platform's FFC cable not connect well- Re-insert it and give another try. If the issue still happen, then change to another new FFC cab...
-
Printer can not connect with PC
If your printer can not connect with PC, but can be initialized from the printer’s button, the issue is from the connection error between your PC and printer. Please check following step by step: 1...
-
Method of replacing CPU, mainboard, interface board, mainboard adapter board and USB power board on UP300
Tools: 3mm hex wrench, cross screwdriver, anti-static gloves 1. Loosen the 4 screws on the rear panel with a 3mm hex wrench and remove the rear panel; 2. Find the PCB board that needs to be replace...
-
Replace nozzle heater- Mini ES
Withdraw the filament: open the upper cover and withdraw the filament Power off the printer, pull out the extruder CFC cable 3. Remove the extruder: push the extruderupwards with both hands(Note...
-
Replace nozzle heater-UP300
Withdraw the filament, power off the printer and remove the nozzle wire cover Pull out CFC extruder cable After removing the fixing screw at the lower left, the extrudercan be removed. Unplug ext...