Cecilia
- Total activity 123
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 63
Articles
Recent activity by Cecilia-
How to Replace Plastic Pulley with Wheel Assembly of UP300
After long-term using, some plastic spare parts may be broken, this article will guide you how to replace Plastic Pulley with Wheel Assembly for UP300. Tools: forward and reverse ratchet screwdrive...
-
How to replace FFC platform on UP mini2/UP mini ES
Power off the printer, pull out the cellboard. Take off heating plate assembly from the four snaps shown. Pull out FFC cable plug from the heating plate. Remove the platform FFC cable from the ill...
-
Platform too hot error
Following possibilities could make Platform too hot error : 1.Platform's FFC cable not connect well- Re-insert it and give another try. If the issue still happen, then change to another new FFC cab...
-
Printer can not connect with PC
If your printer can not connect with PC, but can be initialized from the printer’s button, the issue is from the connection error between your PC and printer. Please check following step by step: 1...
-
Method of replacing CPU, mainboard, interface board, mainboard adapter board and USB power board on UP300
Tools: 3mm hex wrench, cross screwdriver, anti-static gloves 1. Loosen the 4 screws on the rear panel with a 3mm hex wrench and remove the rear panel; 2. Find the PCB board that needs to be replace...
-
Replace nozzle heater- Mini ES
Withdraw the filament: open the upper cover and withdraw the filament Power off the printer, pull out the extruder CFC cable 3. Remove the extruder: push the extruderupwards with both hands(Note...
-
Replace nozzle heater-UP300
Withdraw the filament, power off the printer and remove the nozzle wire cover Pull out CFC extruder cable After removing the fixing screw at the lower left, the extrudercan be removed. Unplug ext...
-
How to replace UP MINI2 Linear rail clip V2?
Totally has 4pcs rail clip( this is UP mini2 rear door view) I. Remove the Z-axis (Z1#, Z2#, Z3#) Linear rail clip: Use the Phillips screwdriver to unscrew the illustrated screws to remove the cor...
-
Nozzle too cool error
Please check following: 1. CFC cable connection issues, check if it was fully seated in the socket, re-insert it. If the issue still exist, replace another new cable. 2. Extruder, the problem may b...
-
Please close front door error
1. there are two magnet inside front frame, and they are assembled by screws, please check if the screws are loose or not, after long time transport or printing, the screw may be loose. 2. please c...