- Total activity 50
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 26
ArticlesRecent activity by Cecelia
Replace the FFC of platform for UP mini2/ES
1.Power off the printer, pull out the cellboard. 2.Take off heating plate assembly from the four snaps shown. 3.Pull out FFC cable plug from the heating plate. 4.Remove the platform FFC cable fr...
Method of replacing wire feeder and wire inspection limit
Tool/ Cross screwdriver 1. Loosen the 4 screws on the rear panel and remove the rear panel.2. Cut off the cable tie of the wire inspection cable, loosen the crimping plate slightly, and then unplu...
Replace FFC cable of platform and motherboard on UP Mini2/ES
1. Power off the printer, pull out the cellboard 2. Take off heating plate assembly from the four snaps shown. 3. Pull out FFC cable plug from the heating plate. 4. Remove the platform FFC cable...
Replacing Extruder transition board V12 - UP BOX+
1. Loose those screws, then take off the extruder cover. 2. Pull out these 3 connectors. 3. Pull out CFC cable connectors then you could take the extruder board off Note: Please pay more attent...
Replacing Nozzle height detection assembly V12.3 on UP BOX+
1. Take off these two screws which located on the aluminium build plate. 2. Remove the plug from the bottom to remove the height detection assembly. 3. Remove the fixed screws and push it out in ...
Replacing LCD Touch screen on UP mini2/ES
Power off the printer, open the front door, forced to open the LCD two brackets. 2. You will see the LCD inside. 3. The SD card is located inside the slot. If there is any problems ...
Replaced LCD Display on UP300
1.Disassemble the aluminum column of the display and loosen the 4 screws of the right icon to release the aluminum column, in order to replace the pulley bracket for the rear. 2.On the back of the...
Changing MINI2 Linear rail clip V2 on UP mini2/ES
Totally has 4pcs rail clip( this is UP mini2 rear door view) Remove the Z-axis (Z1#, Z2#, Z3#) Linear rail clip: Use the Phillips screwdriver to unscrew the illustrated screws to remove the corre...
Replacing the front door magnet on UP mini2/ES
Remove themagnet: Open the front door and use a Phillips screwdriver to remove the 2pcs screw that tightens the magnet under the front door. 2. Removed round magnet andscrews
How to replace Y Axis Linear Rail Guide Assembly on UP BOX+
Tools Cross Screwdriver, 2.5mm Allen Key Take down the right cover before this step, and screw off four bolts on back cover by cross screwdriver Unplug FFC extruder cable from PCB-extruder tran...