Cecilia
- Total activity 123
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 63
Articles
Recent activity by Cecilia-
Nozzle calibration/alignment failed on X5
Users may meet following error when using X5. •Error: nozzle temperature too high •Error: Calibration failed •There is abnormal sound several times when the platform rises to the nozzle and no erro...
-
Software shows that the nozzle temperature or platform temperature is too high on X5
Software reports nozzle high temperature error Printing stops and reports nozzle high temperature error Platform automatically heats up after initialization Software reports platform high tempera...
-
Adjust the platform level on X5
When the printed model has warping and other issues, it may be due to the levelness of the printing platform not suitable. Following is the adjustment method and the method of replacing the levelin...
-
Operation Guide-Method of replacing height aligning sensor
Remove the two screws fixed on the aluminum substrate; 2. Pull out the connector shown in the figure from the bottom to remove the height aligning board component; You can move upwards th...
-
DISASSEMBLE UP300D EXTRUDER
1.Remove the extruder cover in the direction of the arrow 2.Use a hex wrench to remove the screws that fasten fan, heat sink. 3.Remove the two screws that fasten the gasket. 4.Use pliers to c...
-
Method of replacing touchscreen-X5
1. Open the spool chamber on right side 2. The protective cover of the touch screen can be seen in the upper left corner of the spool chamber. Loosen the two fixing screws to remove the protective...
-
CPU Tool
Due to unknown reason, in rare cases, the CPU could be lockup, which result in a situation that motherboard will have long beep when initializing. Here we provide a CPU Tool to reset the CPU back t...
-
Replace the FFC of platform for UP mini2/ES
1.Power off the printer, pull out the cellboard. 2.Take off heating plate assembly from the four snaps shown. 3.Pull out FFC cable plug from the heating plate. 4.Remove the platform FFC cable fr...
-
Method of replacing wire feeder and wire inspection limit
Tool/ Cross screwdriver 1. Loosen the 4 screws on the rear panel and remove the rear panel.2. Cut off the cable tie of the wire inspection cable, loosen the crimping plate slightly, and then unplu...
-
Replace FFC cable of platform and motherboard on UP Mini2/ES
1. Power off the printer, pull out the cellboard 2. Take off heating plate assembly from the four snaps shown. 3. Pull out FFC cable plug from the heating plate. 4. Remove the platform FFC cable...