Maintenance
- Failed to connect UP 300 (Wi-Fi)
- Initialization failed: direct power off
- Print model has staggered layers-UP300
- During printing: Z axis automatically drops / X, Y axis suddenly stops on UP300
- Method of replacing platform FFC heating wire, height aligning cable and platform adapter board on UP300
- Motion system error on UP300
- Platform temperature is too high
- Please close the front door of the printer
- During printing: Z axis automatically drops / X, Y axis suddenly stops
- The device does not start printing after the print info appears
- The nozzle does not extrude filament or the filament is not smooth during extrusion and printing
- Failed to register an account (no activation email received)
- Nozzle calibration/alignment failed
- Failed to connect UP 300 (Wi-Fi), Wi-Fi transmission failed
- Print platform continues to heat up automatically-UP300
- Motion system error 5
- Print model warped or deformed
- Nozzle calibration/alignment failed-UP300
- Failed to connect UP 300 (USB)/USB transfer failed
- Operation Guide-Method of replacing height aligning sensor
- DISASSEMBLE UP300D EXTRUDER
- Replaced LCD Display on UP300
- Method of replacing FFC-Y axis cable and Y-axis limit on UP300
- How to Replace UP300 Touchscreen Module
- Replacing UP300 Auto Leveling Probe Module
- Method of replacing CPU, mainboard, interface board, mainboard adapter board and USB power board on UP300
- Replace nozzle heater-UP300
- How to Replace Plastic Pulley with Wheel Assembly of UP300